Jobs
Project Name : Robotic Hand
Description: A robotic hand is a type of mechanical arm, usually programmable, with similar functions to a human hand; the hand may be the sum total of the mechanism or may be part of a more complex robot. The links of such a manipulator are connected by joints allowing either rotational motion (such as in an articulated robot) or translational (linear) displacement. The links of the manipulator can be considered to form a kinematic chain. The terminus of the kinematic chain of the manipulator is called the end effector and it is analogous to the human hand. However, the term "robotic hand" as a synonym of the robotic arm is often proscribed.
Author:
Md. Rashedul Islam
ID: 211-33-1404
Department of EEE
Daffodil International University
Project Name: Gas Detector Alarm System
Description:
This module consists of an MQ2 sensor that actually recognizes LPG gas. When LPG gas leakage sensed, it will give a HIGH pulse on its DO pin and Arduino constantly reads its DO pin. When Arduino receives a HIGH pulse from the LPG Gas sensor module it displays the “LPG Gas Leakage Alert” message on 16x2 LCD and stimulates Buzzer which beeps again until the gas detector module doesn't recognize the gas in the environment. When Arduino gets a LOW pulse from the LPG Gas detector module, then LCD will show the “No LPG Gas Leakage” alert message.
Author:
Md. Mazharul Islam
ID: 181-15-2070
Department of CSE
Daffodil International University
Project Name: Automatic Hand Sanitizer
Description: An automatic hand sanitizer system was designed, which will be presented in two stages describing the instrument structure and control parts. This work focused on using the elasticity of pumps and improving people’s access to devices. This automated hand sanitizer device is expected to contribute to the disinfection of contactless hands in public places and the prevention of viral infections.
We have designed an automatic hand sanitizer system that is compatible with various containers. When one moves one’s hand close to the device sensor, the hand sanitizer container is pumped once.
Author:
Md. Shamsuzzaman Miah
ID: 173-15-1631
Department of CSE
Daffodil International Univeersity
Project Name: Temperature Based Automatic Fan Speed Controller Using Arduino
Description:
Temperature sensor LM35 sensor the temperature and convert it into an electrical which applied to the algema328 microcontroller of the arduino UNO board. The analog value converted into digital value. The sensor value of the temperature and speed of the fan are displayed on the LCD. When the temperature exceeds 30 ° the fan starts rotating. A low frequency pulse width modulation (PWM) signal, whole duty cycle & varied to adjust x fans speed s used. An single, small, pass transistor like 2N222 or BD139 can be used here it is efficient because the pass transistor is used as a switch.
Author:
Most. Shadia Afrin
ID: 183-15-1010
Department of CSE
Daffodil International University
Project Name: Measurement Helper (Range Measure & Spirit Level)
Description: Measurement Helper (Range Measure & Spirit Level) is an Embedded System based project.
By this project we can easily measure “ Distance, Area, Pitch Angle and Roll Angle”.
We can also monitor the live Temperature by this system.
Author:
Md. Shamsuzzaman Miah
ID: 173-15-1631
Department of CSE
Daffodil International University
Project Name: Earth's Arc Speed and Annual Motion Model
Description:
How day and night are in the world has been explained through this project. Basically, the main goal of this project is to show the speed of the earth again. Day and night are caused by instantaneous motion. A revolution in the Earth's orbit causes instantaneous motion. And as a result of this instantaneous motion, at the same time there is light and day in one part of the earth and no light in another part. So, there is night.
Author:
Shovon Parvez
ID: 201-33-1064
Department of EEE
Daffodil International University
SEO Specialist